Tamiya 58636 TA07 PRO pictures and info

Here is the official Tamiya info for the TA07 Pro. Check out how the belt system works. Also a close look at the chassis shows that there could be some very interesting possibilities with where to take it. I am keen to get my hands on one of these.

Check out the single belt design!

You can mount the motor in 3 different places

The upper frame allows for a symmetrical chassis design, which in turn helps to optimize chassis flex.

The front/rear stiffener, and center brace parts are attached separately to the integrated lower and side frame piece.

The efficient single belt winds back around the main and counter pulleys. Using one belt as opposed to two facilitates the changeable motor position feature. It allows simple reconstruction of the chassis using the existing belt rather than many different lengths.

The 3 motor positions cover a total range of 52mm. Changing motor positions is easy; just take off the cover, remove 2 screws, and re-attach the motor mount in the desired position.

TRF419 suspension parts and gear differentials give top-level performance and reliability. Like on the

TRF419, the servo mount is attached on one side only, with chassis flex in mind. The battery can be removed via the chassis side.

★ "TA" series long-awaited new is the appearance. In order to exert the optimum roll and pitch stiffness, it adopted a characteristic composite chassis that combines the upper frame to a narrow type of Lower Deck.

★ drive system is single belt 4WD. Mounting position of the motor is three points can be selected.

★ TRF419 of foot around the front and rear Giyadefu, use the steering Ackerman.

In addition standard equipped with a high-function parts such as TRF damper and universal shaft. ※ use propoxycarbonyl: Aix-spec GT-I2.4G (set for an electric RC car)

Source - Tamiya.com